RE: [PipingDesign] regular bore valves

From: <varun>
Date: Wed Jun 06 2001 - 08:06:00 EDT

In the regular bore 12" gate valve, the actual diameter of the valve will be smaller than 12 ", and thus there will be a higher pressure drop at full open condition as compared to a full bore 12" gate valve, where the ID of the valve is same as the inlet sizing, and there will be very small pressure drop. Generally used for overhead vapour vent lines (e.g. Recovery of vapours from a crude storage tank) where even a small pressure drop is critical.

Varun Pant

-----Original Message-----
From: sankaranarayanan dalawai [mailto:dmsbhawani@yahoo.com] Sent: 06 June 2001 07:25
To: PipingDesign@yahoogroups.com
Subject: [PipingDesign] regular bore valves

Hello everybody,

Can anybody tell me the difference between a regular bore 12" gate valve and full bore 12" gate valve.

Thanks,
Narayanan

---

Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail - only $35 a year! http://personal.mail.yahoo.com/

---

Piping Design Central
[ http://www.PipingDesign.com ]

---

We hope you find this newsletter useful. If not, you can unsubscribe at:
PipingDesign-unsubscribe@yahoogroups.com Post message: PipingDesign@yahoogroups.com Subscribe: PipingDesign-subscribe@yahoogroups.com

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ Received on Wed Jun 06 08:06:00 2001