Re: designing a pipe erected vertically to release hot exhaust in atmosphere

From: <constant>
Date: Tue Jul 17 2001 - 08:59:00 EDT

Hi,
There are some steps in point form for your consideration:
1. composition of the exhaust gases for flow calculations and material selection (corrosivity) 2. maximum flow expected, eventually worse case scenario or over capacity allowance (if the case) 3. temperature of the exhaust to allow a proper material selection (see 1. too)
4. review of draft requirements
5. pipe to be insulated or not and height of the pipe Of course these is probably not everything you need, but I hope would be helpful. Good luck!

• azimuddin12@hotmail.com wrote:
  > how to design a pipe which is releasing exhaust into
  > atmosphere. the
  > pipe to be installed vertically. inlet pressure of
  > exhaust is 150mbar.
  >
  >
  >
  

  ---

Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail <a href="http://personal.mail.yahoo.com/">http://personal.mail.yahoo.com/</a> Received on Tue Jul 17 08:59:00 2001