Minimum distance between Fittings

From: <agus>
Date: Fri Mar 22 2002 - 23:33:00 EST

Glenn Dillon <glenn.dillon@task-consultancy.co.nz> wrote: Hitesh, assume these are butt weld fittings. Fitting to fitting is preferred but where not possible I work on minimum pup spool distance of 50 mm to allow for weld effected zone and weld efficiency. Haven't had any failures yet. With steam, elbows can be highly stressed and its best to ovoid short pipe sections and layout distribution to allow fitting to fitting.

Hope these comments of some help. Best regards Glenn

-----Original Message-----
From: Ashok Dani [mailto:ashokdani@tatachem.tata.com] Sent: Friday, March 22, 2002 4:29 PM
To: 'pipingdesign@yahoogroups.com' Subject: [PipingDesign] Minimum distance between Fittings Importance: High

> What is the minimum distance required between Bend-Tee or Tee-Tee for
> Steam
> line or as per B31.1?
> Thanks in advance
> Hitesh

---

Unsubscribe: <a href="/group/PipingDesign/post?postID=CR3OUth7e_Jl4wLaf2f5Mi5BIlEXoz3RiXakjIwfAOlB924s-Js731ouvuQgnDNdgm8Yum9EOtR6kzsDk7fLxSfW6xa-YFGSls9sX_VrBg">PipingDesign-unsubscribe@yahoogroups.com</a>

Your use of Yahoo! Groups is subject to <a href="http://docs.yahoo.com/info/terms/">http://docs.yahoo.com/info/terms/</a>

---

Unsubscribe: <a href="/group/PipingDesign/post?postID=CR3OUth7e_Jl4wLaf2f5Mi5BIlEXoz3RiXakjIwfAOlB924s-Js731ouvuQgnDNdgm8Yum9EOtR6kzsDk7fLxSfW6xa-YFGSls9sX_VrBg">PipingDesign-unsubscribe@yahoogroups.com</a>

Your use of Yahoo! Groups is subject to <a href="http://docs.yahoo.com/info/terms/">http://docs.yahoo.com/info/terms/</a>

---

Do You Yahoo!?
Yahoo! Movies - coverage of the 74th Academy Awards®

[Non-text portions of this message have been removed] Received on Fri Mar 22 23:33:00 2002