RE: Nozzle placement in PDS

Mr. Balaji,
It is not like that, There is no need to write a EDEN PROGRAM. I am facing problem because i am very new in PDS.
I think you are actually not aware of it. I have already done it to put 40" nozzle with help of Mr. Nimish Pindaria who was perviously with me and at presently in RIL and also member of this group. If you have any doubt about PDS please contact him (Pl. do not give reply of matter in which you are not knowing the truth)
Parag

> -----Original Message-----
> From: BBalaji@technip-coflexip.com [SMTP:BBalaji@technip-coflexip.com]
> Sent: Friday, May 24, 2002 8:50 AM
> To: <a href="/group/PipingDesign/post?postID=X24WTYq3igwLV1mdnnPcqcLFnUA2SlIx72yWK6jWBsjw4hwD3R78E53Abl93n-2kcqYocIVnWV-D32yAacV-HIE6NQ">PipingDesign@yahoogroups.com</a>
> Subject: Re: [PipingDesign] Nozzle placement in PDS
>
>
> actually programming is available only upto 36" only in pds.
> For placing 40" Nozzle you have write EDEN PROGRAM.
> If you are not aware of it, your administrator might be knowing it,
> just consult him.
> B.MAHESH BALAJI,
> ENGINEER-PIPING,
> TECHNIP KTINDIA LTD.,
>
>
>
>
>
>
> _____________________________________________________
> Unsubscribe: <a href="/group/PipingDesign/post?postID=gnJq9pcHYvcA3Grw5ev8GHdQArBEgkbEJ2t8p6uLvvApZ4FBDQZFpXz8JnFMLSIg6SC7cNiJh9n4tSgYE0SnYFDwqkXYgxUpKOw1gmJeM_nx">PipingDesign-unsubscribe@yahoogroups.com</a>
>
> Your use of Yahoo! Groups is subject to <a href="http://docs.yahoo.com/info/terms/">http://docs.yahoo.com/info/terms/</a>
>
Received on Fri May 24 04:22:00 2002