RE: Dimensions of concentric reducers to ASME B16. 9

From: <James>
Date: Tue Aug 20 2002 - 11:03:00 EDT

Hi Samuel

Thanks for your reply, I do have the code, Table 12 gives only the overall length and the ODs of the ends. I need to know the lengths of the parallel sections at either end of the conical section so that I can calculate the cone angle.

For the moment I have *estimated* that the length of the parallel section is 10% of the overall length, but would like some confirmation that this is a reasonable assumption.

Thanks once again for your reply.

Best regards

Barbara

-----Original Message-----

From: Samuel Liu [mailto:samuel.liu@amec.com] Sent: 20 August 2002 15:33
To: 'James, Barbara '
Subject: RE: [PipingDesign] Dimensions of concentric reducers to ASME B16. 9

Hi, Barbara:

I don't know exactly what you search for, and did you look TABLE 12 DIMENSIONS OF REDUCERS, B16.9-2001? If you don't have the standard in hand, just let me know.

Best Regards,

Samuel Liu

• - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
  -
  IMPORTANT NOTICE

This E-Mail and any files transmitted with it, are confidential and for the
exclusive use of the intended recipient(s). If you are not the intended recipient(s) please note that any form of distribution, copying or use of this communication or the information in it, is strictly prohibited and may be unlawful.

If you have received this E-Mail in error please return it to the sender.
We should be grateful if you would also copy the communication to postmaster@mitsuibabcock.com then delete the E-Mail and destroy any copies of it.

It is your responsibility to scan any attachments for viruses.

For further information, visit us at WWW.MITSUIBABCOCK.COM

[Non-text portions of this message have been removed] Received on Tue Aug 20 11:03:00 2002