Tanmoy
There is a product from Garlock call a Flexseal , it is a Gasket design for
flanges with a chevron system, it as a metallic and a sealing element,
typical 304 and Graphite .
For your application I will chose 316SS and Teflon. It will go to 250 °C .
They comply with ASME B16.20 .
(There also known has Flexitallic)
Arturo M.
> LINE PRESSURE IS FROM 5BAR(G) TO 24 BAR(G). DESIGN
> TEMPERATURE WILL VARY FROM 60 DEG C TO 200 DEG C.
> COMPOSITION IS LIKE THIS.
> 24%H2S, 67%CO2 & 11% H20
> THEORITICALLY NO CHLORIDE IS PRESENT.
> THANKS
> TANMOY
> --- Tuberias Visa Hermosillo <amurillo@t-visa.com.mx>
> wrote:
> > Tanmoy.
> >
> > Line Pressure ?
> >
> > ----- Original Message -----
> > From: "TANMOY SABUD" <tsabud@yahoo.com>
> > To: <PipingDesign@yahoogroups.com>
> > Sent: Monday, October 14, 2002 8:56 AM
> > Subject: [PipingDesign] SS316L(NACE) material
> >
> >
> > > DEAR MEMBERS
> > > what are the limitations of using flat ring gasket
> > in
> > > sour service of 150# class? what special heat
> > > treatment is required for SS16L (NACE) material
> > used
> > > for acid gas piping?if anybody konws please
> > intimate.
> > > regards
> > > tanmoy sabud
> > >
> > >
> > > __________________________________________________
> > > Do you Yahoo!?
> > > Faith Hill - Exclusive Performances, Videos & More
> > > http://faith.yahoo.com
> > >
> > >
> > > Texas Flange - a good source for information on
> > industrial flanges, all
> > they ask is for referrals for designs they help
> > with.
> > > 877-610-8924.
> > > www.texasflange.com
> > >
> >
> =====================================================
> > > unsubscribe:
> > PipingDesign-unsubscribe@yahoogroups.com
> > >
> > > Your use of Yahoo! Groups is subject to
> > http://docs.yahoo.com/info/terms/
> > >
> > >
> >
> >
> >
> >> Do you Yahoo!?
> __________________________________________________
> >
>
This archive was generated by hypermail 2.1.8 : Mon Oct 27 2008 - 20:23:58 EDT