Re: Minimum distance between Fittings
- In PipingDesign@yahoogroups.com, "Glenn Dillon"
<glenn.dillon@t...> wrote:
> Hitesh, assume these are butt weld fittings. Fitting to fitting is
> preferred but where not possible I work on minimum pup spool
distance of 50
> mm to allow for weld effected zone and weld efficiency. Haven't
had any
> failures yet. With steam, elbows can be highly stressed and its
best to
> ovoid short pipe sections and layout distribution to allow fitting
to
> fitting.
>
> Hope these comments of some help. Best regards Glenn
>
> -----Original Message-----
> From: Ashok Dani [mailto:ashokdani@t...]
> Sent: Friday, March 22, 2002 4:29 PM
> To: 'pipingdesign@yahoogroups.com'
> Subject: [PipingDesign] Minimum distance between Fittings
> Importance: High
>
>
>
> > What is the minimum distance required between Bend-Tee or Tee-Tee
for
> > Steam
> > line or as per B31.1?
> > Thanks in advance
> > Hitesh
>
>
> _____________________________________________________
> Unsubscribe: PipingDesign-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
Received on Wed Mar 26 13:57:00 2003
This archive was generated by hypermail 2.1.8
: Mon Oct 27 2008 - 20:23:59 EDT