Re: Pump Room

From: <Geoff>
Date: Sun Mar 23 2003 - 16:13:00 EST

Paul,

many thermoplastic materials such as ABS, PE etc have 5D pulled bends as it itoo costly to manufacture elbows >DN400 with injection moulds. You have to get out more . There is life outside of refineries you know.

Geoff
--- Paul Bowers <pbowers@pipingdesign.com> wrote:

---

Check out the radii on these elbows:

<a href="http://norfolkgraphics.com/graphics/pumproom.jpg">http://norfolkgraphics.com/graphics/pumproom.jpg</a>

Yahoo! Groups Sponsor

---

Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com - LMNO Engineering,
Research, and Software, Ltd.

---

unsubscribe: <a href="/group/PipingDesign/post?postID=ADavW0cH6TUf3TQLpv1Oj4VEROF0PF-WvB969A31EGE5Sz8dbujUshJFgqP77YB6vbzxDRZERxdVFbqr8ACM8ujkDc13a2p51KKx4EiWqxrJaNE">PipingDesign-unsubscribe@yahoogroups.com</a>

---

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---

Design Detail and Development (a division of Blenray Pty Ltd) We specialise in pipe network and waterhammer analysis, pipe stress analysis, the design of buried pipelines and thermoplastic pipe systems.

Overseas tel 61 2 402 35 2313 fax 61 2 8850 2313 mobile 0402 35 2313 Mail Address PO Box 1351 Castle Hill NSW 1765 Australia

---

Do you Yahoo!?
Yahoo! Platinum - Watch CBS' NCAA March Madness, live on your desktop! <a href="http://platinum.yahoo.com">http://platinum.yahoo.com</a> Received on Sun Mar 23 16:13:00 2003