Can anybody tell ...
About the upstream and downstream length requirement for the flow element ( specifically orifice flanges ) for the water service piping.. I know 10D for upstream and 5D for down stream piping length Is required .Is it applicable for all cases or any deviation can be accepted??
How this lengths are decided ? I will be thankful if someone explain in detail with some document references.
Thanks
Chetan
Chetan Prajapati
L&T-Sargen & Lundy Ltd.
Vadodara
Visit us at www.lntsnl.com
Disclaimer: This e-mail and any files transmitted with it are intended solely for the use of addressee(s) only and may contain confidential and/or privileged information. Any view or opinion presented in the said e-mail is solely those of the author and do not necessarily represent those of Larsen & Toubro - Sargent & Lundy Limited. If you are not the addressee, then this message is not intended for you and be advised that you have received this e-mail in error and that any use, dissemination, forwarding, printing or copying of this e-mail is strictly prohibited. In such case, please notify to the sender and delete the e-mail and any attachments with it from your system immediately. Receipt of this e-mail by you shall not give raise to any liability on the part of Larsen & Toubro - Sargent & Lundy Limited.
[Non-text portions of this message have been removed] Received on Wed Jun 11 01:05:00 2003
This archive was generated by hypermail 2.1.8 : Mon Oct 27 2008 - 20:24:00 EDT