RE: Struts

From: <Naha>
Date: Tue Sep 23 2003 - 08:09:00 EDT

NO...YOU SHOULDN'T NORMALLY DESIGN IT FOR THE SAME. Regards.
Jaydeep.

Siemens AG.

-----Original Message-----
From: Tushar Rajyaguru [mailto:trajyagu@ltcis.ltindia.com] Sent: Dienstag, 23. September 2003 17:44 To: piping design
Subject: [PipingDesign] Struts

Dear Friends,

We are planning to use strut in one piping system. My query is whether strut can take compressive load ? Generally we have used it in tension only.

---

"NO EFFORT IN LIFE GOES UNPAID, HENCE GO AHEAD"

---

Tushar K. Rajyaguru
Plant & Piping Engineering,
Larsen & Toubro - Chiyoda Ltd.,

[Non-text portions of this message have been removed]

---

Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com - LMNO Engineering, Research, and Software, Ltd.

---

Information presented on this list is given as helpful advice, nonsense, carefully-considered calulation or any combination of the above. The intent is to spark discussion and encourage knowledge-sharing amongst professionals. If you blow yourself up by doing stuff remotely described by info gleaned from reading this list, you are an idiot.

Your use of Yahoo! Groups is subject to <a href="http://docs.yahoo.com/info/terms/">http://docs.yahoo.com/info/terms/</a> Received on Tue Sep 23 08:09:00 2003