Re: (unknown)

From: <George>
Date: Wed Oct 15 2003 - 09:16:00 EDT

Maximum recommended velocity is also going to depend on other factors. With gases, you may get into creating high noise levels and erosion of the internal surface at velocities above 40-50 ft/sec.

George McKinney

• Original Message ----- From: apghasemi To: <a href="/group/PipingDesign/post?postID=NAfjS1a5aYChYBeYbMXoo1QJtsfE7BUlqjIaoyrYLB6I64bXAyfEIX_Xnet1F6HggDGQNF5JLAwWNu3dh7p6Xu_f">PipingDesign@yahoogroups.com</a> Sent: Wednesday, October 15, 2003 1:55 AM Subject: [PipingDesign] (unknown)

   THANKS,
     what is the recomended velocity in line sizing?    in piping hand book,steam velocity is about 50m/s.    but i have seen in some spec. this velocity is between 20 to 30 m/s.

   but what is yr recomended velocity same as liquid(3-4 m/s)?    thanks

         Yahoo! Groups Sponsor

---

   Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com - LMNO Engineering, Research, and Software, Ltd.

---

   Information presented on this list is given as helpful advice, nonsense, carefully-considered calulation or any combination of the above. The intent is to spark discussion and encourage knowledge-sharing amongst professionals. If you blow yourself up by doing stuff remotely described by info gleaned from reading this list, you are an idiot.

   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

[Non-text portions of this message have been removed] Received on Wed Oct 15 09:16:00 2003