RE: Piping repair-sleeve/clamp

From: <Steve>
Date: Wed Oct 29 2003 - 06:01:00 EST

Hey Barbara
is there a website that describes your plant? Have got a bit out of date on conventional generation, so a brush up would be appreciated.

Cheers

Steve McK

-----Original Message-----
From: barbaraj@babcock.co.za [mailto:barbaraj@babcock.co.za] Sent: Wednesday, October 29, 2003 11:49 PM To: PipingDesign@yahoogroups.com
Subject: Re: [PipingDesign] Piping repair-sleeve/clamp

Iman,

I have just looked through BS806 : 1983 Edition. I can't find any reference to this sort of pipe repair. Is this intended to be a permanent repair, or just a short term fix?

I am aware that BS806 has been superseded by BSEN13480. BS806 is still in use in the nuclear sector, which is specifically excluded from the new BSEN. I am currently working in a conventional power plant in South Africa where they still use BS806.

Good luck with your search for information...

Barbara

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+

Dear All;

Does anyone know about standard or reference for clamp or sleeve for piping repair, As far as I know, B 31. didn't mention about this kind of repair (specifically)

regards,

Iman

---

Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com - LMNO Engineering, Research, and Software, Ltd.

---

Information presented on this list is given as helpful advice, nonsense, carefully-considered calulation or any combination of the above. The intent is to spark discussion and encourage knowledge-sharing amongst professionals. If you blow yourself up by doing stuff remotely described by info gleaned from reading this list, you are an idiot.

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ Received on Wed Oct 29 06:01:00 2003