RE: Straight runs for flowmeters

From: <Aaron>
Date: Thu Oct 30 2003 - 08:50:00 EST

I work in pharmaceutical piping mostly. The Flow meters that I've used have a requirement for 3-6 OD's length of pipe upstream of the instrument. What this does is get a more laminar flow out of the product which provides better accuracy in measurement.

Regards,

Aaron Wolfe
Piping Designer
Paul Mueller Company
P.O. Box 828
Springfield, Mo 65801
(417) 575-9780
E-mail: <a href="/group/PipingDesign/post?postID=OJWkOP8ZSQJqIyN9_BnCX4mF7AiRT0QCAyNeJJ_F8viuH2Vgl1DD1-ty8N01rLoMfdg0Ev5lQ_sDkA">awolfe@muel.com</a>

-----Original Message-----
From: Paul Bowers [mailto:pbowers@pipingdesign.com] Sent: Wednesday, October 29, 2003 8:42 PM To: <a href="/group/PipingDesign/post?postID=vjQ9oNsl5mtJpdD7QuODrl2Tt5cndlnpdLg0VT8LxuAZ4yHWbRTgCJV_KeE-BCJXqr3EEzvD-Quj9GqaDByXRb17SqtsTA">PipingDesign@yahoogroups.com</a> Subject: [PipingDesign] Straight runs for flowmeters

Perhaps some of our instrumentation/flow specialists could throw some light
on the concept of minimum upstream/downstream piping for flowmeters.

I think we've discussed this before (search 5708 previous PipingDesign Group
messages at http://groups.yahoo.com/group/PipingDesign/messages) but it's
always worth a recap.

Paul

---

Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com - LMNO Engineering, Research, and Software, Ltd.

---

Information presented on this list is given as helpful advice, nonsense, carefully-considered calulation or any combination of the above. The intent is to spark discussion and encourage knowledge-sharing amongst professionals. If you blow yourself up by doing stuff remotely described by info gleaned from reading this list, you are an idiot.

Your use of Yahoo! Groups is subject to
<a href="http://docs.yahoo.com/info/terms/">http://docs.yahoo.com/info/terms/</a> Received on Thu Oct 30 08:50:00 2003