its called coffin analysis (vessels or piping) and has to be developed by the
engineer in custom relation to the job. Dresser has an off the shelf version.
- Original Message -----
From: xmansu
To: <a href="/group/PipingDesign/post?postID=Kv_ILsx5xOgMEfZBRRVzUrMWtDxDTAlq_gFGH4FAp1iEKKiB-KnNKx6ALBYLK6kICRrTykE6NS62OD-MJ1flaa9xPTCNiCk">PipingDesign@yahoogroups.com</a>
Sent: Sunday, November 16, 2003 7:22 PM
Subject: [PipingDesign] mechanical clamp on design
- In PipingDesign@yahoogroups.com, "xmansu" <imansg@u...> wrote:
> Dear All;
>
> I'm looking for a guidance in determining/design bolt on clamp for
> piping leak repair. As I see on ASME B 31.3; API 574 or even API 6
H,
> there's no clear definition,
> Please share yours
>
> rgds,
>
> Imn
Yahoo! Groups Sponsor
ADVERTISEMENT
========================================
Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com
- LMNO Engineering, Research, and Software, Ltd.
Information presented on this list is given as helpful advice, nonsense,
carefully-considered calulation or any combination of the above. The intent is
to spark discussion and encourage knowledge-sharing amongst professionals. If
you blow yourself up by doing stuff remotely described by info gleaned from
reading this list, you are an idiot.
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]
Received on Mon Nov 17 14:21:00 2003