RE: Horizontal travel

From: <Naha>
Date: Tue Dec 16 2003 - 09:24:00 EST

Dear Karan,

Check for the 4 degree offset criteria.....maybe you can use a longer support if the layout so permits.
You can also use a Bottom Hitched support too, if its a tight case. Anyway, if it meets the 4 degree angle criteria, then it should be okay.

  With best regards,
  Jaydeep Naha.
(Senior Piping Engineer)
  Siemens AG (Power Engineering Ltd.).

  Phone            : 91-124-2842000  (Extension:2029)
  Direct number    : 91-124-2842029
  Fax              : 91-124-2347512
  Mobile           : 9811185519
  Email            : Jaydeep.Naha@siemens.com

-----Original Message-----
From: kumar k [mailto:kumar_k21k@yahoo.com] Sent: Dienstag, 16. Dezember 2003 12:50
To: PipingDesign@yahoogroups.com
Subject: [PipingDesign] Horizontal travel

I have one Hanger type spring support:-
Travel Y= 20mm (Vertical)

           Z=  50mm
           X= -50mm

There is so much offset (horizontal travel) during working. And spring is tension.

What I do?

karan

---

Do you Yahoo!?
New Yahoo! Photos - easier uploading and sharing

[Non-text portions of this message have been removed]

---

Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com - LMNO Engineering, Research, and Software, Ltd.

---

To leave this list, send a blank email to: PipingDesign-unsubscribe@yahoogroups.com

---

List home: http://groups.yahoo.com/group/PipingDesign/ Main site: http://www.pipingdesign.com

Yahoo! Groups Links

To visit your group on the web, go to:
  http://groups.yahoo.com/group/PipingDesign/

To unsubscribe from this group, send an email to:   PipingDesign-unsubscribe@yahoogroups.com

Your use of Yahoo! Groups is subject to:   http://docs.yahoo.com/info/terms/ Received on Tue Dec 16 09:24:00 2003