Re: Required guidance for selection of piping span

From: <Alok>
Date: Wed Jan 17 2007 - 02:38:00 EST

This is very basic question. I assume that you are working on a project. There will be guidelines and spans chart t, use them. If these project documents are not available for any reason, do refer piping books & guide. Major criteria are allowable bending moment and the maximum sag for vertical supports.
configuration of piping also plays a role in placing the support.

i strongly suggest to do your own calculation and discuss it with your supervisor before applying them.

Good Luck!

• Original Message ---- From: kiransinhzala <kiransinhzala@yahoo.com> To: <a href="/group/PipingDesign/post?postID=9iJIwP5CA8OeFxY-U7bO95BreXWssaDZFaw0-JUcrCRJw1M4_5PtFGoaRjDPyZEfdw3Zd0W2xeARkax0uohHxeGxUTfrQqg">PipingDesign@yahoogroups.com</a> Sent: Sunday, January 14, 2007 12:23:03 PM Subject: [PipingDesign] Required guidance for selection of piping span

Dear Gentlemen,

Please guide me to select piping support span for 3450I.D. 39.7mm Thk & 2450 I.D. 28.7mm thk pipe. Service is Sea Water for cooling purpose. Design Pressure 6 Barg & design temp. is 50 Deg. C.

Regards

Kiransinh Zala
Abu Dhabi.
U.A.E.

________________________________________________________________________________\

---

TV dinner still cooling?
Check out "Tonight's Picks" on Yahoo! TV. <a href="http://tv.yahoo.com/">http://tv.yahoo.com/</a>

[Non-text portions of this message have been removed] Received on Wed Jan 17 02:38:00 2007