Hey,
For one of my projects last year i had to find a
material with very lower friction coefficients and
very low wear rate.
The material i found was a diamond like coating called
Dylyn. Check out this website for infor on it. I dont
know if this is useful to u but u can give it a try.
http://www.bactusa.com/index.cfm
Regards,
David Wilkinson
- mechengr1977 <mechengr1977@yahoo.com> wrote:
> sure you may use a teflon pad for the slide plate(im
> going to get a
> flak on this once since a lot may argue that pfte
> temp limit is
> under 200C).
>
> _______________________________
> >
> > "Hossein Ahmadi" <h.ahmadi@n...> on 09/23/2002
> 02:06:23 PM
> >
> > Please respond to PipingDesign@y...
> >
> > To: <PipingDesign@y...>
> > cc:
> > Subject: [PipingDesign] PTFE plate
> >
> >
> > Dear Group Members
> >
> > I will appreciate if you answer following question
> :
> > If temperature of pipe be ~500 C(930 F),can I use
> PTFE plate
> > under 4" shoe support ?
> > If no, what do you recommend?
> > Is there any general rule for PTFE plate or
> another material
> selection to
> > reduce friction factor ?
> > Best regards
> > Hosein
> >
> >
> >
> > [Non-text portions of this message have been
> removed]
> >
> >
> >
> >
> > Texas Flange - a good source for information on
> industrial
> flanges, all
> > they ask is for referrals for designs they help
> with.
> > 877-610-8924.
> > www.texasflange.com
> >
>
> > unsubscribe: PipingDesign-unsubscribe@y...
> >
> > Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>
>
Do you Yahoo!?
Yahoo! Mail Plus - Powerful. Affordable. Sign up now.
http://mailplus.yahoo.com
Received on Tue Nov 26 22:47:00 2002