Re: Plastic Material Calculation of stresses at

From: <Geoff>
Date: Thu Jul 31 2003 - 01:38:00 EDT

Chris,

I have been playing around with Roark and Young with the Mathcad Electronic Book that I have. Unfortunately the models are all in Imperial units. CH12 in R & Y at 12.7 gives some insight but continually cautions you on how large errors can occur.

I'll have a look at Nozzlepro and see if there is anything in that software.

Cheers

Geoff
--- Christopher Wright <chrisw@skypoint.com> wrote:

---

>ANy good papers/software/books that cover this design requirement?
This case is covered in Roark.. The conservative approach is to analyze it as a ring subject to dead weight supported at a point on the bottom. The equivalent shell problem is a lot more work--do it according to WRC 107 or the equivalent updated versions.

Christopher Wright P.E.    |"They couldn't hit an elephant at
chrisw@skypoint.com        | this distance"   (last words of Gen.
___________________________| John Sedgwick, Spotsylvania 1864)

http://www.skypoint.com/~chrisw

Yahoo! Groups SponsorADVERTISEMENT

================================================================================\

---

Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com - LMNO Engineering, Research, and Software, Ltd.

================================================================================\

---

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---

Design Detail and Development (a division of Blenray Pty Ltd) We specialise in pipe network and waterhammer analysis, pipe stress analysis, the design of buried pipelines and thermoplastic pipe systems.

Overseas tel 61 2 402 35 2313 fax 61 2 8850 2313 mobile 0402 35 2313 Mail Address PO Box 1351 Castle Hill NSW 1765 Australia

---

Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software http://sitebuilder.yahoo.com Received on Thu Jul 31 01:38:00 2003