Re: [PipingDesign] Strut

From: <Rajesh.Balapure@ril.com>
Date: Wed Sep 24 2003 - 01:22:00 EDT

                       SubrataP Saha
                                                To:       Rajesh V
Balapure/JAMNAGAR/RIL@Reliance
                       09/24/2003 10:45         cc:
                       AM                       Subject:  Re: [PipingDesign]
Strut
                                          Importance: Normal  Sender's OU:
Reliance |------------------|
                                                                                   
| [ ] Confidential |
                                                                                   
|------------------|




                       SubrataP Saha
                                                To:      
PipingDesign@yahoogroups.com
                       09/24/2003 10:44         cc:
                       AM                       Subject:  Re: [PipingDesign]
Strut

I would like to share an interesting interaction will a reputed vendor on piping struts about an year back.(the name I do not wish to disclose for obvious reasons).
With regard to the straight forward question as to whether the load capacities as mentioned in their catalogue is valid for both tension and compression, a prompt reply came that they are applicable in both directions. Subsequently a follow up query on a theoritical case whether a 3m long strut can behave like a shoe support if connected from bottom was put to them. This time the reply was not forthcoming and after followup we came to know that the matter was being discusssed by the specialists. But the final decision has not yet arrived and the catalogue values remain same.
I will leave at this stage and hope the group can very well figure out the reply on the basis of sound engineering judgement and not specious arguments.

Regards
S.Saha
FDC - Piping
Reliance Refinery
Jamnagar
India Received on Wed Sep 24 01:22:00 2003

This archive was generated by hypermail 2.1.8 : Tue Mar 09 2010 - 00:20:46 EST