Re: Horizontal travel

From: <conor.walshe@alcan.com>
Date: Tue Dec 16 2003 - 16:46:00 EST

Karan,

In respect to Horizontal deflection of Spring Hangers, you need to know the total length of the Spring hanger support and work out the angle of deflection of the Spring Hanger from the Vertical. This - depending on the supplier/manufacturer - should not exceed 4 degrees.

Regards

Conor

kumar k <kumar_k21k@yahoo.com>
16/12/2003 05:20 PM
Please respond to PipingDesign

         To:     PipingDesign@yahoogroups.com
         cc:
         Subject:        [PipingDesign] Horizontal travel

I have one Hanger type spring support:-
Travel Y= 20mm (Vertical)

           Z=  50mm
           X= -50mm

There is so much offset (horizontal travel) during working. And spring is tension.

What I do?

karan

---

Do you Yahoo!?
New Yahoo! Photos - easier uploading and sharing

[Non-text portions of this message have been removed]

---

Discussion List sponsor: The fluid flow calculations website - www.LMNOeng.com - LMNO Engineering, Research, and Software, Ltd.

---

To leave this list, send a blank email to: PipingDesign-unsubscribe@yahoogroups.com

---

List home: http://groups.yahoo.com/group/PipingDesign/ Main site: http://www.pipingdesign.com

Yahoo! Groups Links

To visit your group on the web, go to:
  http://groups.yahoo.com/group/PipingDesign/

To unsubscribe from this group, send an email to:   PipingDesign-unsubscribe@yahoogroups.com

Your use of Yahoo! Groups is subject to:   http://docs.yahoo.com/info/terms/

[Non-text portions of this message have been removed]
Received on Tue Dec 16 16:46:00 2003