What is Parallel?

From: <gasket_guru>
Date: Fri Jan 23 2004 - 09:15:00 EST

When preparing to bolt up a gasket between two flanges, if a pipefitter were to say the flanges were "out of parallel", what exactly would he mean by this?

Would he mean:

  1. Each flange face is flat, but relative to the mating flange, the sealing surfaces are not pareallel to EACH OTHER, or
  2. The sealing surface of each flange itself is not flat, but "wavy" or "warped", or
  3. Something comletely different.

Finally...are there any ASME spec's regarding allowances or tolerances for A. or B.

Regards,

Davis Received on Fri Jan 23 09:15:00 2004

This archive was generated by hypermail 2.1.8 : Mon Oct 27 2008 - 20:24:02 EDT