MILL TOLERANCE

I have basic doubt
whether any piping analysis software takes care regarding mill tolerance? I am working on CAESAR II,it's mill tolerance 12.5% negative. but if I am using less thickness than required thckness (1.125times the calculated thickness) then also it is showing pass in the final report, but it is giving warning message that your pipe thickness is less than the calculated one.

from the above warning message I did understand the exact meaning of mill tolerance.
any one guides me regarding this matter.

regards
j.suresh
fdc,real
jamnagar
india Received on Thu Apr 08 05:31:00 2004