RE: Banching from pipes

From: <Patrick>
Date: Tue May 04 2004 - 20:48:00 EDT

You are a big dickhead

Regards,

Patrick LaLonde

-----Original Message-----
From: Christopher Wright [mailto:chrisw@skypoint.com] Sent: Tuesday, May 04, 2004 7:55 PM
To: Pipingdesign
Subject: RE: [PipingDesign] Banching from pipes

>Try
>a 36" main and a 24" branch Carbon Steel assembly.
I think of 36" material as a pressure vessel, not pipe, actually, but that's just a personal issue. Anyway ytour point's taken.

With anything larger than 18 inches, you can send a welder inside to finish off the joint, and have a pretty good job. You can NDT the joint with your process of choice, too. (And if you have an intern, a few threats will send him in with a camera, too, so you can see the work ;-> ) Smaller pipes are a different story, though.

Christopher Wright P.E.    |"They couldn't hit an elephant at
chrisw@skypoint.com        | this distance"   (last words of Gen.
___________________________| John Sedgwick, Spotsylvania 1864)

http://www.skypoint.com/~chrisw

---

PipingOffice - Excel Spreadsheets for Piping Calculations http://www.pipingoffice.us/

---

Main site: http://www.pipingdesign.com

Yahoo! Groups Links Received on Tue May 04 20:48:00 2004