Pipe support-Trunnion reinforce pad

From: <Ipakchi>
Date: Thu Jun 24 2004 - 03:55:00 EDT

Dear All,

Regarding Trunnion Pipe supports , I've seen different books, project specs &..... but unfortunately I couldn't found any rule to use or not using reinforce pads in trunnions( for process industry / Normally CS pipes).

In some project specs, using of them recommended for supporting pipes with large NPS (16" or larger) but in some others I've seen the table for reinforced trunnion supports 3" NPS and above!!!

Shortly, Is there any certain criteria for using or not using of Reinforce pads in design of Trunnion pipe supports.

Thanks.

Ali

• CONFIDENTIALITY NOTICE *****

This message (including any attachments) contains confidential information intended for a specific individual and purpose, and is protected by law. If you are not the intended recipient, you should delete this message. Any disclosure, copying, or distribution of this message, or the taking of any action based on it, is strictly prohibited. Received on Thu Jun 24 03:55:00 2004