Re: [PipingDesign] Difference in No-pocket & No trap terms

From: <Sajit>
Date: Wed Jul 20 2005 - 09:54:00 EDT

a pocket is a high point between 2 low points, a trap is the opposite.

Sajit
--- abdul aziz vayani <azizvay72@yahoo.com> wrote:

---

Greeting everyone

During the development of refrigeration piping layout, It is observed that some lines have a caution of "No-pocket" & some have "No trap" on P&IDs. Have same meaning of these two terms or Is there any difference in both terms. clarification is required in case of any difference.

Thanks in advance.

---

Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com

[Non-text portions of this message have been removed]

---

PipingOffice - Excel Spreadsheets for Piping Calculations
http://www.pipingoffice.us/

---

Main site: http://www.pipingdesign.com

       SPONSORED LINKS Mechanical engineering

    Mechanical engineering jobs

            Cad drafter
                                Process piping
                           Mechanical




---------------------------------

   YAHOO! GROUPS LINKS      Visit your group "PipingDesign" on the web.

     To unsubscribe from this group, send an email to:   PipingDesign-unsubscribe@yahoogroups.com

     Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---

---

Yahoo! Messenger - NEW crystal clear PC to PC calling worldwide with voicemail http://uk.messenger.yahoo.com Received on Wed Jul 20 09:54:00 2005