<a href="/group/PipingDesign/post?postID=AdgGvyTEc0F0pKhpfZg1mzimfdS3hdqSPLD1fDiOKZ0_YsoQHigUV638vLQKUpzAL41-4Zh5_hjBhkHC0g">animesh.singh@ril.com</a> wrote:
> Dear friends...
>
> I am looking for the Vendor of the Steel Pipe bending machine for 1.5D
> radius.
> I am searching in google....but need the expertise & experience on
> selection.
>
> Animesh Singh
> DAKC, C block, Gr floor
Perhaps look at
<a href="http://www.tubenet.org.uk/cgi/reg505uus.pl?md=viewadd&alue=usa&laji=bend">http://www.tubenet.org.uk/cgi/reg505uus.pl?md=viewadd&alue=usa&laji=bend</a>
Try asking Juha (the site's owner) for advice.
Paul Received on Sat Sep 03 18:01:00 2005
This archive was generated by hypermail 2.1.8 : Tue Mar 04 2008 - 11:40:43 EST