Re: Fram Lewis Filters

From: <Geoff>
Date: Thu Oct 27 2005 - 22:02:00 EDT

Chris,

The vessel doesnt have a code plate.

The vessel is 1000mm diameter 1500mm high approximately.

Geoff

Christopher Wright <chrisw@skypoint.com> wrote:

> My question is what would be the allowable pressure,
> including surge, according to ASME for this filter?
> I was thinking that the design pressure would be
> higher than the working pressure?

The ASME Code only concerns itself with the maximum allowable working pressure which must be equal to or greater than the expected normal service pressure. The margin between ordinary service and the MAWP is set by the owner or the owner's rep and could be about anything and will be set to accomodate pressure increases due to surge or other loads. The Code plate BTW isn't the same thing as an ID tag placed by the manufacturer. If the vessel has a Code plate, it'll carry the ASME 'cloverleaf' and the MAWP and maximum allowable service temperature. If the vessel doesn't have an actual Code plate it's not a Code vessel. How big is it? Is it stationary?
Christopher Wright P.E. |"They couldn't hit an elephant at <a href="/group/PipingDesign/post?postID=EHK0qD41grARWDoaMPA6oeDBJMef1YvI0RYdljBvYh4tdiw1fCsN_e3sGIQa-YLL3NNe2gOiEBHCubiAzg">chrisw@skypoint.com</a> | this distance" (last words of Gen.

____________________| John Sedgwick, Spotsylvania 1864)

<a href="http://www.skypoint.com/~chrisw">http://www.skypoint.com/~chrisw</a>

---

PipingOffice - Excel Spreadsheets for Piping Calculations <a href="http://www.pipingoffice.us/">http://www.pipingoffice.us/</a>

---

Main site: <a href="http://www.pipingdesign.com">http://www.pipingdesign.com</a>

---

YAHOO! GROUPS LINKS      Visit your group "PipingDesign" on the web.

     To unsubscribe from this group, send an email to:   <a href="/group/PipingDesign/post?postID=vmYJzPMzVGIzj_zBw79nthcBbFOObmAIUuhw1L3kCtmyBXGwu4oUY2zwjqlOl1hx4VFD8ztiGwYNlYTqBWPwwwCFlrgfFXzXTJEWtxNWDqM">PipingDesign-unsubscribe@yahoogroups.com</a>

     Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---

Design Detail and Development (a division of Blenray Pty Ltd)

Mail Address PO Box 1351 Castle Hill NSW 1765 Australia Tel Mob 0402 35 2313 Office 02 8850 2313 AH 02 8850 2324
We specialise in pipe network and waterhammer analysis, pipe stress analysis, the design of buried pipelines and thermoplastic pipe systems.

[Non-text portions of this message have been removed] Received on Thu Oct 27 22:02:00 2005