Re: Selection of Spring Hanger

From: <HPRAJAPATI@ltcis.ltindia.com>
Date: Thu Dec 08 2005 - 22:49:00 EST

Dear Babu,

You can select the common spring by defining theoretical cold load and spring rate at the bottom of spring spreadsheet in CII. But you need to check manually 25% variation.

Regards,
Hitesh
LTC "S.Babu" <slb@ramboll-qatar.com>
Sent by: PipingDesign@yahoogroups.com
08/12/2005 08:18 PM
Please respond to
PipingDesign@yahoogroups.com

To
PipingDesign@yahoogroups.com
cc

Subject
[PipingDesign] Selection of Spring Hanger

Can anyone tell me, how to select a common spring hanger, which will be used
in typical piping layouts.
Total 10 piping system has been analyzed separately in C-II and each needs one spring hanger. The results for all the 10 systems are, Hot load varies between 3600 N to 6000 N and the vertical up between 40 to 60 mm. C-II had selected the different Sping size for each system. As per the requirement, we need to suggest a common spring hanger, which should work for all 10 piping system.
For selecting one common spring hanger, do I need to take the average value
of the above mentioned hot loads with higher travel ? Is this the correct way of doing it?
Can anyone clarify the same

Thanks & Regards
S.Babu
Ramboll
Qatar

[Non-text portions of this message have been removed]

---

PipingOffice - Excel Spreadsheets for Piping Calculations http://www.pipingoffice.us/

---

Main site: http://www.pipingdesign.com

SPONSORED LINKS
Mechanical engineering
Mechanical engineering jobs
Cad drafter
Process piping
Mechanical

YAHOO! GROUPS LINKS   Visit your group "PipingDesign" on the web.

  To unsubscribe from this group, send an email to:   PipingDesign-unsubscribe@yahoogroups.com

  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

[Non-text portions of this message have been removed]
Received on Thu Dec 08 22:49:00 2005