Re: Re: pIPING THICKNESS CALCULATOR

From: <Geoff>
Date: Sat Dec 24 2005 - 17:56:00 EST

SO management failed to put a system in place. A moot point I think!

   Geoff

tomcruz55 <tomcruz55@yahoo.com> wrote:

   and the conclusion of the investigation is - management failures. Actually the article says the lack of management system is the root cause of failure.

• In PipingDesign@yahoogroups.com, Paul Bowers <pbowers@p...> wrote:
  >
  > Geoff Stone DD&D Australia wrote:
  >
  > > I have sent Paul an article related to a failure investigation
  at a refinery in the UK. There the corrsion was identified and I am sure all the steps you descriibe were put in place but finally mamnagement didnt approve the budget or give the go a ahead or decided to adopt a higher risk profile.
  >
  > Here's the article, converted to PDF:
  >
  > http://www.pipingdesign.com/articles/refinery_explosion.pdf
  >
  > Paul
  >
  

  ---

PipingOffice - Excel Spreadsheets for Piping Calculations http://www.pipingoffice.us/

---

Main site: http://www.pipingdesign.com

---

   YAHOO! GROUPS LINKS      Visit your group "PipingDesign" on the web.

     To unsubscribe from this group, send an email to:   PipingDesign-unsubscribe@yahoogroups.com

     Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---

Design Detail and Development (a division of Blenray Pty Ltd)

Mail Address PO Box 1351 Castle Hill NSW 1765 Australia Tel Mob 0402 35 2313 Office 02 8850 2313 AH 02 8850 2324
We specialise in pipe network and waterhammer analysis, pipe stress analysis, the design of buried pipelines and thermoplastic pipe systems.

[Non-text portions of this message have been removed] Received on Sat Dec 24 17:56:00 2005