Re: [PipingDesign] AutoPLANT Vs PDS / PDMS

Do you use Spoolgen or I-Sketch?

"Using I-Export, users can export new or modified pipes produced in I-Sketch to create new or as-built 3D piping models in plant design or pipe stress analysis systems."

I'm not sure if that means that field-drawn as-built sketches of individual lines can be imported into an existing model, but that would be cool.

Paul

Ed Engalan wrote:
> Paul,
>
>
>
> Yes you are right . Cadworx although the least expensive Piping Software
> around
>
> is easy to operate and maintain. We are Automotive Design and Build
> Mechanical
>
> Contractor and we just completed a full 3D Model Project. Our Cadworx held
> it's
>
> ground against quickpen, autoplant, etc.
>
>
>
> Personally, based on our experience from this 3D Model Project, the best
> softwares
>
> that are available to us Mechanical Contractors are :
>
>
>
> 1.) Cadworx (plant 3D/2D layout)
>
> 2.) Navisworks (auto interference check & virtual 3D project navigation)
>
> 3.) Iso-Gen (auto 3D fabrication isometrics)
Received on Fri Jul 11 15:31:00 2008